Technical Diagnostic Search
Heating Element Thermal Cut Out
Error code E02 designates an open-loop or thermal cut-out event on the primary heating circuit. The microcontroller detects an unexpected drop in element current or an abnormal temperature rate-of-rise divergence, triggering an automatic shutoff via the safety relay to prevent thermal runaway.
FlexStyle Red LED Motor Stall
The bottom indicator LED ring flashes red when the onboard microcontroller detects a brushless DC (BLDC) motor stall, abnormal back-EMF, or excessive current draw typically caused by severe inlet filter clogging, mechanical impellor obstruction, or inverter gate driver overcurrent trip.
ERR2 Lid Latch Sensor Fault
The main control board detected an open circuit or state mismatch from the Combi Cooker lid/door interlock microswitches during high-heat or pressurized steam operations, triggering an ERR2 safety shutdown.
HV Battery Isolation Resistance Degraded
The Battery Management System (BMS) detected that isolation resistance between the High Voltage (HV) bus (positive or negative) and the vehicle chassis ground has fallen below the safety threshold (typically <500 ohms/volt or <100 kOhm total), entering a degraded drive or turtle mode to prevent shock hazard.
800V Bank Contactor Communication Fault
The High-Voltage Battery Management System (BMCe) has lost CAN-FD/LIN communication with the internal battery bank-split contactor control module. On the PPE platform, the 800V pack splits into two 400V banks via internal pyrofuse and contactors for 400V DC fast charging; loss of communication inhibits contactor actuation and triggers an immediate high-voltage red instrument cluster warning.
MicroSD Controller BSOD Crash
Kernel-mode BSOD (Bugcheck 0xD1) triggered when the Genesys Logic or Realtek SD card reader driver accesses an invalid paged memory address at elevated IRQL during high-throughput I/O burst writes, exacerbated by thermal throttling and unstable PCIe ASPM link states.
EA 229 Flame Loss Lockout
Lockout code EA sub-code 229 indicates the control board detected an unexpected flame extinction during an active firing cycle after successful ignition. Safety monitoring circuit tripped due to ionization current dropping below the minimum threshold (<1.0 µA DC).
Base Station Heating Module Fault
Fault 108 is triggered when the base station power management MCU detects an open circuit, short circuit, or thermal runaway condition in the mop-washing PTC/instant heating module, preventing 70°C water sanitization.
I2C HID Controller Failure
Windows Device Manager reports Code 10 (This device cannot start) for the I2C HID Device corresponding to the Embedded Controller (ITE IT8223E/IT8987E MCU interface). The root cause is a communication timeout or corrupted handshake on the SMBus/I2C line interfacing the onboard gamepad controls, macro paddles, and LED lighting with the APU.
Flashing Red LEDs Airflow Cutout
The main microcontroller has tripped the software thermal protection routine due to restricted intake airflow or high-limit NTC sensor threshold exceedance (>115°C/239°F at the heater barrel), de-energizing the heating element and shutting down the high-speed BLDC motor to prevent thermal runaway.